Hi Bea, Here's a screencap (top image) I did of your LW room with a Vickie mesh I have for converting some stuff for her, it looks like the figure you imported into LW was the problem, it must have been scaled up a good bit, the one I've used here is exported with no world transformations, your best bet is to rescale the whole thing in LW, select all the layers and press (shift) 'H', then press 'N' for the numeric window, (I know you probably already know this, it's just a habit I've gotten into when I'm explaining stuff), and set the scaling factor to about 55%, then press the apply button, you'll end up with something about the same as the middle image. if this is too much, just alter the scaling factor. I understand this will mean you'll have ro redo the whole thing in Poser, but I think you'll find it easier than trying to rescale everything in Poser itself.

If it's just the doors you need to scale, then select just the layers with the doors and the wall they're attached too, then in points mode select all the doors and just the surrounding parts of the door in the wall, you can then use the stretch tool, just 'H' on the keyboard, and using the numeric window just scale these parts down along the Z axis to around 55% to 60% (bottom image), this should stop the chandelier from hitting Vic on the head lol. if this is what you need and you've already set up the room as a figure, you can import just the altered parts and using the replace body part with object command in Poser just swap the old parts for these newer ones.

Hope this all makes sense and is of some help to you, I'll still send over what I've done here so you can have a look at the files yourself.

Billy

hope this is of some help