The transmap folder is temporary - according to the instructions I've had you can delete it (and the OBJ) after importing to Bryce. DAZ|Studio has limits set to on, unlike Poser. This applies to both morphs and joint settings so if you've ramped BreastSize8 up to 5.000, or bent the limbs too far (which isn't far at all for some) they will reset - check what happens if you enable Figure>Use limits in Poser before exporting (after saving - it won't undo). You can release the limits on individual dials in D|S by double-clicking the dial name, so for joints and body part morphs you could save a pose and reapply it in D|S; Full Body Morphs are another matter. Make sure you have QuickTime installed so that Bryce can read the PNGs used for the transmaps.