Hi Khai,

I was surfing about and saw your post and luckily I was just looking at this one previously-

http://hometown.aol.com/visualranger/eg-tut.html

I just did this recently with a multi part prop I created, It was easy enough using a CR2 editor (I use CR2Editor02k) to simply cut the geometry info from the CR2, paste it into a txt file and resave the txt file as an obj file to the correct location (minus the braces( ) (note not a smilie).

There are a couple of lines of code you need to replace the geom with I think they are-

storageOffset 0 0.3487 0
and
:Runtime:Geometries:props:whateverthefileis.obj

make sure you have no stray braces ( )

Hope for all the more experienced CR2 wranglers this sounds ok.

Cheers,

Simon.