Sorry, I'll try again ... "Correcting controller" (newly coined) is a controller - Partial Body Dial that, when set to 1, will return the pose of the new (zeroed) figure to that of the old (zeroed) figure . Hope I make sense so far ... The way to obtain the Corrector is to : Superimpose the new figure on the zeroed old figure in Poser . Adjust the dials of the new figure till the pose matches that of the old figure . Save out a pose . Open the pose in a text editor, and check the rotational values . Create a Partial Body Dial on the new character with those rotational values that are non zero . Poses created with the old figure can then be applied to the new figure; and if the Partial Body Dial is set to 1, this should correct the poses for the new figure .