Next... Down in the figure section remove all of the materials, as shown (or rather they aren't shown, because thay are gone!) (Note 1) Then (Note 2) change the default pick to the head (you did name the group of the helmut "head" didn't you?) Remove all the "weld" command lines, because the head will be the only actual part, the upNeck is just a positioner, it doesn't have any mesh. Note 3 - make the upNeck a child of the BODY, remove all the other childern lines for the parts that aren't there any more. Note 4 - you can change the name here, if you like, or do it in Poser. You will aso have to turn bending off for the helmet too, I did that in Poser, just pick it and get properties, and turn it bending off. That should do it, I can't recall anything else, oh- save the CR2 as helmet.cr2 in the library folder, too. Once you've done this a coulp of times you can do it in a couple-5 minutes.