You'll have to do something with their feet. The one on the left should probably have both her feet under water, or at least covered in sea foam, the one on the right should have her right foot at least the same way. You could try a flat square with a water/foam texture on it set at a high level of transparency, use the wave deformer on it (radial) to create a ripple and place one of these above each foot that is in the water. You'll have to experiment some to get the best effect. Also they are standing on wet sand. Their feet would tend to sink into the sand just a bit. This would be easier to accomplish in postwork, I'm not sure how I'd go about it in Poser other than just dropping their feet through the floor just a tad. good luck, hope this helps some, Unizipped