Nate opened this issue on Aug 30, 2005 ยท 49 posts
ShawnDriscoll posted Mon, 12 September 2005 at 9:29 PM
In both Amapi and Hexagon I can clone half of a female figure and mirror it. Then I can pull and push points, edges, and facets around on either half of the figure and the other half will mirror it (in real-time). I can leave one or both halves smoothed or un-smoothed as I model the figure. When I'm done fussing with it, I weld both halves together and apply smoothing to the entire figure. It takes three mouse clicks to clone a half and mirror it. Then I can add/delete polys to the figure as if it was one object.
I don't remember if I use the SHIFT key while doing any of this. It just happens without thinking about it.
Message edited on: 09/12/2005 21:32