Forum: Poser - OFFICIAL


Subject: P6 & corrupted pz3s

linkdink opened this issue on Sep 24, 2005 ยท 4 posts


richardson posted Sat, 24 September 2005 at 7:29 AM

Attached Link: http://www.renderosity.com/messages.ez?Form.ShowMessage=2406795

Do you have External Binary morph targets enabled? If no,,Did you save or use any characters in library with .PMDs (binary) enabled prior to disabling it? Have you "cleaned out" any folders where you save your PZ3's? I do NOT want to start bad info but unless you are making mechandise, or are incredibly impatient, you do not need "Binary targets". May I suggest,,,get everything the way you like in matroom, rendersettings and in poseroom. Scroll up to P6 in character library. EDIT> Set Prefs> uncheck "Use Binary Morph Targets" and anything else that suits you. Set Prefs. EXIT P6 Reinstall P6 (as before) and SR1 Reboot Start up P6 and go to EDIT > prefs to be sure it is still the same (this I cannot remember). If you change anything in prefs, close P6 and reopen it to take effect. There will be some residual problems for a while until P6 clears itself of binaries. Open and resave your characters in Figures This is a bandaid. Not a cure