If you want it for your own and only for P6 its very simple. You need a figure without any morphs, for V3 you get it as V3 Blank SAE, for other figures you can use Morphmanager to remove teh morphs, or you can do it by hand, clicking on the morph and remove it. To this empty figure you apply your morph, switch on use external morphs and save the figure under a specific name. Switch off external morphs! The next step is to create the Pose file. It is a very simple one like this: { version { number 6 } injectPMDFileMorphs RuntimeLibrariescharacterV3yourmorph.pmd } It should be 7 lines of code, in older Poser versions there was a CR (Enter) needed at the end of the file. Poser 6 doesn't need this anymore (to my experience). For other Versions of Poser you can use the same figure, saving it without external morphs, copy the vertex information in a pose-inj file and use this with readscript, but this is too long and complicated for a forum.

---

Ulli

"Never argue with an idiot. They drag you down to their level and beat you with experience!"