Sorry in a hurry, but if U want to, just send me the materials U want, where U want em, and Ill uv texture it for U. It wont be til probably tomorrow morning, but it should do it. again sorry but a tad busy. In PS U just use the transform menu to twist around (rotate, skew, distort). Thats the good thing about UV Mapping, U create your OWN map and apply it to the model. Bring the BMP file in PS, put a texture on it, save it as JPG and load in Bryce. See how it comes out. Then, go back to PS, do a few lines here and there, save it again, and load in Bryce, see where the lines went. This will show U and U will learn faster by doing the texturing. Once U figure out where each section is, then U can load all your metals and texture it in PS. Once U put the texture on the BMP file I sent U with the model (in Photoshop), just do a few black lines here and there, see where they appear in Bryce, and U will figure it out believe me. I did it the same way to learn and now works great. Either way, just email me all the stuff and how U want it if U cant figure it out, and Ill do it for U, and show U the final and how I did it. Thankx