In response to your IM this will help...

1. Load Poser then the model. Don't bother playing with textures.

2. In Poser Click File -> Export. Select Wavefront .obj
   Then Use these settings...

2.a File->Export->Wavefront Obj.
2.b Select single frame
2.c Just OK the Hierarchy Selection dialogue.
2.d Save it to a directory/folder where you'll remember it (I used My Documents as everyone has that).

Tick: Include body part names in polygon groups.

Tick: Use exact internal names except spaces

Tick: Include figure names in polygon groups

UN-Tick: Include existing groups in polygon groups

Tick: Weld body part seams

UN-Tick: As Morph Target (no world transformation)

3. Leave Poser running and fire-up some UV Mapping software.

Theres a free 1 called UVMapper at www.uvmapper.com, and a forum here to help you with that. My personal prefence is for LithUnwrap. Which the screenshots show, but whatever software you use the basic principle is the same.

4. Mapping.
   Load the .obj you exported from poser.

The picture will most likley look a little jumbled up (as above). read the next post

Pinky - you left the lens cap of your mind on again.