Attached Link: Conf.zip

Nomuse, the reason I asked the question in my last post is that if you think you have a sure fire sequence of adding and deleting figures that can break the scene I would like to try it out. Just tell me what order to add and delete the characters and conformers, and I'll give it a go.

I have tried loading 3 characters, then 3 conformers, deleting the middle character and conformer, then loading a new character and conformer, then saving and relaoding the pz3. This did not break the slaving in any of the conformers, but it's always posible that there is some sequence of loading and deleting that will break it. So I you think you know a sequence that will break it, I'm keen to try it out!

I am also attaching a link with the character and conformer I used in my experiments. Note that the morph in the conformer slaves directly to the morph in the character. The character you want to conform to MUST be selected before the conformer is loaded. The morph in the character is slaved to a FBM in the body, but you should NOT use the FBM in P4, use the morph in the characters chest. In P5 you can use the FBM. They are P4 figures, so you should have the geometry on disk.

Message edited on: 03/01/2006 20:13