heyas; yeah, just run the figure obj through uvmapper. everything will work fine. honest! :) once you're done, re-save the obj, but remember to delete the geometry rsr that goes with it before you re-open poser. er... unless you used the new method of creating a figure, with the hierarchy editor embedding the geometry in the cr2. in that case, you need to create the chopped obj first. that isn't so hard. just turn off all ik, open the jp window, and hit the 'zero figure' button. make sure the hip and body trans dials are zeroed. and there's no scaling on the figure. then export for use as the base obj. putting the base obj into the old cr2 will be a bit more tricky and involved, but not impossible. you will need to replace each body part's "geomcustom" branch with two branches, a storage offset branch and a geometry pointer branch. just follow the format that is in a normal poser figure, it's not that hard.