Just a word o' warning - especially if this topic is directed at V4:

If you actually change the limit values (min/max), you may also be affecting master-slave relationships.  WTB, you should be keenly aware that a slave dial (with valueOp...) cannot be set past its min or max values by its master dial(s).  VK clued me in to this and experiments definitely bear this out!

In other words, changing min and max for a dial willy-nilly and inconsiderate of possible slaving of that dial could end you up with a whole bunch of strange behaviour.

I mention V4 because if you look inside the CR2, there are thousands (!!) of master-slave relationships (just take a gander at the linkParms list in the figure section - you can clamp your jaws back into place now).  ;D

C makes it easy to shoot yourself in the foot. C++ makes it harder, but when you do, you blow your whole leg off.

 -- Bjarne Stroustrup

Contact Me | Kuroyume's DevelopmentZone