Quote - I have a question concerning this ExP tech.

Let's say that you install V4.1 and run the updater.  Then you load it up in Poser, do your thing, and save a Poser scene.  Later on, you purchase other morph packs and install them and update V4.1.

When you load the scene (which no longer references the V4.1 CR2!!!!) and want to make some changes to the figure - say add some of the morphs you recently purchased - how do you do it?  :D

I see a V4.2 in our near future........

 

From what I'm seeing, it all aggregates together - all the updater does is add guaranteed-unique morph control channels when you run it, for any INJ morph that it locates for V4.  Which is imo a bit stupid, but according to that DAZ forum faq (supposedly backed up by DAZ tech support) the morph data isn't loaded, it only assigns a channel.  Later you install 5000 INJ morphs, and run the updater.  All the scenes reference the same CR2 file, but the CR2 file loads different sub-files - so all versions of scene files SHOULD still work seamlessly.  It's pretty messy, there are maybe 8 sub-files for every bodypart.  I cannot confirm that it does not load the morph data either, I see morph data in the files - don't know whether it's loaded when you load V4 into Poser.  

I have very few INJ poses installed, I make my own morphs and save in separate CR2s.  Such being the case I have little interest in this ExP junk and have no plans to use it.

My Freebies