heyas; it's pretty easy, pd. first, put the armor on the horse, there, then zero up the horse (use the jp window to zero the pose, then move the hip/body to 0.0.0 trans), and then you can export or assemble all the pieces into one obj. after that, you'll need to slice the mesh... actually, i THINK you could just get away with using the hip, chest, and head. (perhaps abdomen, too). then plug your obj into a horse conformer. if you grab my free horse blanket or harness, use that cr2, because it is all set to conform to the horse. then load it into poser on your horse, and tell it to conform... and see how it turns out :) the upper legs and lower neck will affect the hip and chest area, which is why you might not need to slice leg pieces out of them. you could also see about adding a neck-piece chain mail bit. say, if you have a buncha horse armor links, could you send 'em to me? ;)