Forum: Poser - OFFICIAL


Subject: Why is displacement breaking this model?

muralist opened this issue on Jun 03, 2008 ยท 38 posts


bagginsbill posted Wed, 04 June 2008 at 6:57 AM

Here is another illustration.

You can force Poser to pretend an edge is not welded, even if it is, by adjusting the "Crease angle" on the object.

Here are four Poser Hi-res spheres. The first has no displacement - the other three have a uniform 1 inch displacement.

#2 crease angle=80 - all smooth
#3 crease angle=10 - partial separation of some polygons
#4 crease angle=6 - total separation of some polygons


Renderosity forum reply notifications are wonky. If I read a follow-up in a thread, but I don't myself reply, then notifications no longer happen AT ALL on that thread. So if I seem to be ignoring a question, that's why. (Updated September 23, 2019)