chris1972 opened this issue on Jun 12, 2008 · 10 posts
ockham posted Thu, 12 June 2008 at 10:12 AM
Point lights will usually do this job. Set the Dist Start to about 0.5 and adjust
the Dist End until it looks good from outside.
The wireframe picture as suggested by Muralist will show if other problems
exist. One big possibility is that the windows were formed by a type of
Boolean cut that doesn't subdivide the mesh. If the windows are just holes
in one big facet, Poser won't understand them as holes, and won't let light
go through.