HI There.

Wanna let you know, that i finally found the problem. Simple, but i have no idea Why DAZ Does that: The issue always only appears when a figure was loaded, however, not on all figures. So i began comparing the CR2 files line by line.
The problem is, Poser some writes the core of a figure as BODY, sometimes as BODY:2 or so, depending if you have more than one in your scene. My figures with a ":x" at the end all worked ok in DAZ, so i replaced all the BODY entries in the CR2 with BODY:1 and BOOOM it works in DAZ.
So whyever, if you use BODY:1 instead of BODY in your CR2, the textures load fine.

Just to let you know, this was really annoying...
;)

 

3-D-Cs Facebook Page: 3-D-C on Facebook

Check the K-Azonica Story and World Evolving:   K-Azonica

Check my website and products and the large freebie section:   3-D-C