OK ... I've created 2 JCMS at this point. Something is wrong.

1. JCM set for 100% at -40 degree bend.
2. JCM2 set for 100% at -70 degree bend.

I'm using DS Figure Setup Tools: Morph Loader Pro. What happens is that there are some polys that now get distorted until the joint bends to negative 70 degrees. Not all of them.

I've tried adding the JCMs several times to make sure that I followed the most important steps:

1. Reverse Deformation is checked yes on import.
2. Set the JCM to 100%.
3. Set up the ERC freeze.
4. Set the limits to 0 to 1.
5. Set limits on.

Any advice is much appreciated.