Forum: 3D Modeling

Subject: WIP: Simple Morphing Chess Piece - Advice On The Knight?

3dcheapskate opened this issue on Sep 08, 2010 ยท 24 posts

3dcheapskate posted Thu, 30 September 2010 at 6:54 AM

And here's all six pieces, created from the same*** twice-subdivided cube (with two extra horizontal edge loops added near the bottom of each piece to create the rounded base). The biggest problem this time was the king.

As always, constructive criticism is very much appreciated.

*the knight actually has an extra horizontal edge loop near the base that I forgot to remove.

The 3Dcheapskate* occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.

*also available in ShareCG, DAZ, and HiveWire3D flavours (the DeviantArt and CGBytes flavour have been discontinued).