fivecat,

Quote - Just tried out flo hair in Poser 8 and it loaded and conformed fine on odf's Antonia, but if I try to conform the hair on my cr2 that references odf's something goes wrong. Does anyone know how I could have managed to mess up conforming with my cr2?

I don't know the answer. I converted the hair in P6, which involved saving the hair figure from the Poser interface back to disk a number of times. The hair worked fine for me in P6, but when EnglishBob tried it in P7 it went seriously spastic. The values for the joint centers had changed or been truncated. I went through all the 'origins', including the 'Offset' channels and the center points on the 'joint' channels, and restored them to Antonia's original values. After that it worked OK for Bob in P7. I'm thinking that P7 and later may be hyper sensitive to the location of the joint centers, and any disparity between the conformer and the character.

The only thing I can think to suggest is, make a copy (outside of Poser) of the original Antonia cr2, then use a cr2 editor, or Morph Manager, to move the morphs into that new cr2.