Ok guys,

So I have installed hypervue on my main PC along with rendercow - rendercow also install on my 2nd PC. Both are currently contected to a netgear switch via their on board 10/100 cards-for the time being. And both PC are hooked up to a KVM.

However...When working on the main PC - I cannot see if the rendercow is working. And when I render something it only shows my main PC's x4 cores in the bottom resource bar? I cannot see any new option relating to Hypervue in the top tabs - edit, render ect..and there doesn't seem to be anything to show that rendercow is setup or running?

1. do I need to have Vue Esprit 9 also installed on the 2nd PCs along with Rendercow?

2. I am not currently using cat 6 - was going to get some today. Could this be causing the problem?

3. How do I check the builds?

Any advice would be greatly appriciated.

Thanks,