Forum: Poser - OFFICIAL


Subject: Create displacement maps for V4 in Zbrush Material grouping issue

Zev0 opened this issue on Oct 11, 2011 ยท 24 posts


Zev0 posted Wed, 12 October 2011 at 5:39 PM

I use "weld at seams" on export from poser because without it, the mesh breaks up at the seams in z-brush after sub-division. If there is an alternative fix for that then please let me know. Could it also be because I am not saving my displacements at a high pixel count? Would saving it at like 4000 pixels perhaps solve it? Also I checked my alignment of my maps, they are precise.

My Renderosity Store