wolf359 opened this issue on Nov 22, 2011 ยท 296 posts
millighost posted Wed, 23 November 2011 at 6:26 PM
Here is an attached cube, which has two morphs: one that resizes the top square in the x direction, and one that goes in the z-direction. An additional master dial drives both morphs; it drives the x-morph for negative values, and the y-morph for positive values. So, unless there is some specific bug specifically with morphs controlled by joints, this should work (or i did not understand those IFs correctly). It uses valueKey parameters, which were not in some older version (at least they are not in the BLRender-book, so they were added somewhere after Poser 5), but it works with Poser 8. I guess with the (older) valueOpDeltaAdd-Style morphs, something should work, too.