Forum: Poser - OFFICIAL


Subject: Cost of custom products

elfguy opened this issue on Dec 09, 2011 ยท 45 posts


LaurieA posted Wed, 14 December 2011 at 9:49 AM

I use Roadkill in conjunction with UVMapper Pro. Roadkill has that nice LCSM ;). It does a really good job of laying things out nice and flat if you have a minimum of knowledge on where the cuts should be. The only downside is that it destroys the grouping and material zones. You can get em back with UVM. I do use Wings to do uvs, but I almost always end up sending it through Roadkill..lol.

Laurie