Forum: Poser - OFFICIAL


Subject: Antonia - Opinions?

odf opened this issue on Oct 27, 2008 · 13933 posts


lesbentley posted Fri, 16 December 2011 at 11:29 PM

 

Some time ago I mentioned that I might make a conforming figure to act as a kind of host for any earring geometry that people might like to add to it. It's taken longer than I expected. I ran into some problems, not all of which have been completely resolved, and the demands of the season have also slowed things down, but I now have a beta version of the "DIY-Earrings".

Occasionally in some of my tests, I ran into an issue where the material room display would get locked into a perpetual refresh cycle. This only happened sometimes. I was unable to trace the cause, and am not sure if the problem is fixed.  Saving the figure then reloading it seemed to cure the problem when it did happen, but I can't guarantee this will always work.

I'm wondering if anyone would like to test the beta version. If so, send me an internal message with an email where send the zip.

The package contains some poses to inject stock  rings and chains  if desired, and there are some example earrings that can be injected into the figure. There is a short PDF tutorial included that covers some of the basics of adding your own geometry to the figure. I'd be very interested in any constructive criticism of the tutorial, as I'm not sure that I have explained things well.