I've been trying to make a transparancy pattern in P9 for the DAZ Fantasy wrap, but I keep getting the vague outlines of the wrap as a whole.  Any suggestions?

In the Material Room, make sure your Transparency edge and falloff percentages are set properly.

It sounds like you have the edge setting wrong.

Transparency edge is most likely the culprit.

Also make sure you don't have any specular over the entire object. If you do have specular, plug your transparency map into the specular value. That way you won't have any spec outside the white areas.

Laurie

One other thing.....make sure you render to see the effect of your transparency settings.  You will still see an outline in the preview window, but not in render if your settings are correct.

Transparancy edge was the issue!  Thanks, guys.

Dont forget to put gamma to 1 if you use a map.

OP is using P9, Anthanasius.  No render gamma to worry about.

:b_lipssealed: