Whatever I add will be separate geometry.  It was real pain to build the light geometry and then weld it into the mesh of the helmet.  I think I'll make a little ridge surrounding whatever I want to add in, duplicate those faces and scale that by 0.995% (to create a fine crevice between the helmet and the module) and build whatever I build from that base.  That way I can put whatever Modules I want into the 'slot' without too much trouble

I'll worry about how to code the whole thing later.. I havent mucked around inside a poser file yet so I'll have to suck up some courage first

 

Quote - > Quote - I'm not entirely sure how to do some of it (geometry switching, and calibrating my monitor to be specific)

There are two parts to geometry switching, code to identify the geometries, and a channel to swap between the different geometries. Note that what follows is from a figure. I have not tested it in a prop.

Here is an example that will swap between 4 different geometries (including the default), you would place this code immediately above the 'channels' line in the actor you want to swap the geometry for:

    alternateGeom   geom_001
        {
        name geom_001
        objFile 1001 :Runtime:Geometries:YourName:ProductFolder:object_001.obj
        }

    alternateGeom    geom_002
        {
        name geom_002
        objFile 1002 :Runtime:Geometries:YourName:ProductFolder:object_002.obj
        }

    alternateGeom    geom_003
        {
        name geom_003
        objFile 1003 :Runtime:Geometries:YourName:ProductFolder:object_003.obj
        }

Then add this channel as the last channel in the channel stack:

        geomChan AltGeom
            {
            uniqueInterp
            name AltGeom
            initValue 0
            hidden 0
            forceLimits 1
            min 0
            max 3
            trackingScale 0.045
            keys
                {
                static  0
                k  0  0
                }
            interpStyleLocked 1
            }

The name "AltGeom" is just an example, you can use any name. "The 'max' limit should be equal to the number of alternate geometries. When the dial is set at zero the default geometry will be used. To have a blank geometry (no geometry) you can either leave the geometry out of the base obj for that actor, or you can create an empty file named "blank.obj" and use that as one of the geometries to be swapped.

For adding parts to a helmet, it may be better to create an extra actor as a child of the helmet, and switch geometry for that part, rather than switching between different versions of the whole helmet.