Forum: Poser - OFFICIAL


Subject: Displacement Intensity Question :

pumeco opened this issue on Mar 27, 2014 · 21 posts


pumeco posted Thu, 27 March 2014 at 3:37 PM

**@bagginsbill** Thanks for that, you got me worried I'd have to start doing maths for a minute there!

I'm a bit confused regards what you said about the math node so I tried it they way I've been doing it.  I just drive the Displacement directly from a 2D Image Node and it works, it gives me both positive and negative displacement even without a math node, and with ZBrush displacement set to 0.5.

I've pulled everything into one screenshot to show you what I mean.  Note that although the"Mid" control is greyed-out now in ZBrush, it actually is set to 0.5, it's just that 0.5 isn't half way along the slider.  But yup, didn't need to do anything fancy, all I did was a quick low-res displacement, flipped it vertically and exported it with the "Mid" slider set to 0.5.

In Poser, it just drives the Displacement directly, no math node needed, I just set to 0.007500 out of preference.

@Paolo
Just in case you're curious what displacement controls ZBrush has, check-out the basic Displacement Panel that's open in this screenshot.  There's another Displacement panel as well, for "Vector Displacement" but I've not even looked into that one yet - I don't think I need it.