TinaK opened this issue on Jun 20, 2014 ยท 17 posts
3dcheapskate posted Fri, 27 June 2014 at 6:07 AM
I'd guess that you can probably just do the download bit with the DLM (making sure NOT to click any 'Install' buttons, despite it tempting you to do so), and then copy just the copy the nine executables to your other machine and run them each in turn. But that is just a guess.
Alternatively perhaps copy the whole of the SmithMicroDLM folder to your machine once everything's downloaded?
You really need Jenn or SM support to confirm that though.
The 3Dcheapskate* occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.
*also available in ShareCG, DAZ, and HiveWire3D flavours (the DeviantArt and CGBytes flavour have been discontinued).