EClark1894 opened this issue on Sep 16, 2014 ยท 134 posts
Male_M3dia posted Thu, 18 September 2014 at 5:10 AM
Quote - > Quote - That workflow to set up a new shape makes me cringe...
All you're doing is dragging a joint center from one point to another and recording it. What's cringe worthy about that? Basically, everything else was converting Andy to weightmapping because he isn't a weightmapped figure.
You would have to understand steps to do the same thing in DS:
Enter Joint editor tool
Right click on shape, select "Adjust Rigging To shape"
Click "OK"
Done.
(You can also select which joints and surfaces of the mesh you wanted as well, that takes about another 20 seconds to figure out which)