Snarlygribbly opened this issue on Dec 17, 2013 ยท 582 posts
3dcheapskate posted Thu, 30 October 2014 at 4:24 AM
Just completed a big test render (took all day) with EZSkin2 and IDL - fantastic, with more work needed on my part to set things just right.
Now started playing with EZMat to try and get some jewellery looking good. Got the plugins loaded and the presets imported, but I ran into two problems:
EZMat doesn't seem to know about the selected figure (see attached image) even after pressing 'Sync' - I tried closing EZMat, going the material room and opening it again. Same problem.
Even with drag-docking disabled it always docks if I drag it in the material room. (Edit: I tried again several times - same problem. Tried again and it works properly, doesn't dock. Go figure!)
Any ideas anybody?
(Poser 9.0.3.23027, Windows 7, EZMat v1.1 build 0102)
The 3Dcheapskate* occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.
*also available in ShareCG, DAZ, and HiveWire3D flavours (the DeviantArt and CGBytes flavour have been discontinued).