EldritchCellar posted at 8:31PM Sat, 09 January 2016 - #4248122

Just being an obnoxious Devil's Advocate as usual, PikesPit. [...]

Ah, no problem with this - better safe than sorry. Thank you!

---

EldritchCellar posted at 8:31PM Sat, 09 January 2016 - #4248122

[...]As far as changing the end point on the hip? You should be able to just grab the end point with the translate tool (while in set up room) and move into position. Or enter numeric values in the joint editor end point axis fields. [...] editing the values in the .cr2 to no effect, which in most cases is a brute force tactic. [...]

Yes that's indeed the case - none of this works, the end point stays pinned to the right - no idea why.

Regards,

Peter