Forum: Poser - OFFICIAL


Subject: Extract geometry from .cr2

Darkworld opened this issue on Jun 15, 2016 ยท 11 posts


icprncss2 posted Thu, 16 June 2016 at 8:52 PM

This is a figure not a prop, correct? What app did you use to create the mesh that you used to create the cr2? Since P5, Poser by default places the obj file in the same folder as the cr2 rather than in the geometry folder. That is not the same as the obj being embedded as often happens with props. Overly simplified: I model the mesh, group and map the mesh, save as an obj, load the obj into Poser, to into the set up room, rig, go back to the pose room and save the newly rigged figure to figures library. Poser generates the cr2 and places the obj file in the same folder when the figure is saved to the library.