I send this feedback on their site.

I downloaded and tested Bella-Beta. PS ; I am a beta tester for Smith Micro Poser

So far I found :

• The obj file is not symmetrical. About 300 vertex pairs are not symmetrical.

• All groups are unwelded in the obj file.

• And all vertex at all welds have a double. You have 1639 doubles. (All verts at all welds have a double.)

• The weightmap painting also has different weights on the double vertex at all welds. Mostly visible in the Shoulders when bend.

• The weightmaps and the bulge maps are fighting each other. => Also in the collar-shoulder area.

REMARK : Did you use the obj file that Poser exported for you from the setup-room? Because these obj files do NOT work, and always have to be replaced by externally build and properly grouped and welded obj files.

Poser only saves out individual groups, and uses its internal rewelding system to reweld the groups to a single figure at import when you load the cr2.

This would explain that the figure is not symmetrical any more, (Poser also adds a slight shift in X at obj file safe), that all groups are unwelded and that you have 1639 double vertex in the figure.

If required, I can make a video with my findings, or send screengrabs if you provide an e-mail address.

Best regards, Tony