MistyLaraPrincess posted at 10:28AM Tue, 02 May 2017 - #4304096

Did some research into it, one printer site recommends meshlabs to clean up the geometry.

"Clean up" and "repair" is a broad subject. It is true Meshlab has some of these functions, however, its also true that its not generally considered for this work.

Netfabb, Geomagic, and Materialise are the industry standard. Netfabb was the only affordably priced one for individuals or small businesses; however, since it was bought by Autodesk it has been switched to a high priced subscription service.