Thank you for helping me out!

In fact (as I experienced it) you only need the V4.2 base and the V4.2 Morphs++ (which now seem to be renamed to "Shapes++" for no obvious reason). Everything else is optional only, but not needed for the figure to work.

Once you have Sasha-16 installed, look for the other options that are supported by the figure.It comes with a couple of premade installers which you can run straight from the setup folders,. From what I've experienced, any other injections made for V4 can also be applied.

Remember, it's just V4 again, but with a big lot of improvements.

regards, Peter

Re. your posted screencap:

All you need is

• Victoria 4.2 BASE (last in your list)
• Victoria 4.2 Shapes++ (sixth from top)

Peter