@ NikKelly

Actually I work with Groboto, LW, Carrara and Blender . All work just fine bridging with Poser sending for the rigging back and forth. What I can tell FBX is an option but not the best choice. Sure PMX and XPS would be an option but it would result being a real mess as of it might subdivide your Body Parts and you would end up with a load Conformed Parts. Your whole rigging would explode like stepping on a Land Mine LOL, you could not merge the parts also not to forget a smooth subdivision would also rip apart the polygons as these mostly are not Merged. You have no alternative then to rebuild the whole Polygon surface to have a clean mesh, a main reason why FBX can cause issues.

Not the FBX it self is the issue but how the mesh surface is build up and where the geometry coordinates are of the Parts you Import , Import is always zero of the geometry , allot of times it is not how you see it while you work on it. So from my experience there is nothing to be fixed :) it all works like a charm. It is not the version you use to Import it is how you build the Bridge between the Import and Poser.

This is the figure I am working at , like mentioned it is fully rigged in 1 hour and Poser ready. Had no time today to work on it, so will work a little on the texturing and Adjust the Joint orientations before I release it .

And NikKelly stay on it I am sure you are going to figure out a good way as it all works like a charm ....