GGari posted at 6:56PM Wed, 11 August 2021 - #4425003

did what Phil said. Crashes in material room. Eh I guess I'll hope they fix it.

Try this:

1. SLOW DOWN....that is a hard one for me but it truly helps. Do Not make a move until the node(s) fully refresh after making a change.
2. Close the Preview pane of the nodes - it does not seem to crash nor hang if the Preview is not open. After making your change then click and preview, close it again if you are going to make more changes.

A bit of a pain, slows the workflow down, but I have NOT had a single crash since making these two changes (and I am a FAST clicker and key tapper....)