Forum: Poser 11 / Poser Pro 11 OFFICIAL Technical

Subject: Creating a new master parameter that works modulo 360 - can it be done ?

3dcheapskate opened this issue on Sep 13, 2021 ยท 20 posts

3dcheapskate posted Mon, 13 September 2021 at 4:21 AM

Also I've just realized that, of course, there's nothing special about the x/y/zRotate dials - no modulo 360 stuff going on there.

It is, of course, the way that they're used in the 3D simulation code that does it.

So my question is actually really simple:

"How can I add two numbers modulo 360 using valueOp maths ?"

The 3Dcheapskate* occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.

*also available in ShareCG, DAZ, and HiveWire3D flavours (the DeviantArt and CGBytes flavour have been discontinued).