undefined posted at 10:36 PM Sat, 25 September 2021 - #2965775

(This is a rewording of this post, but as a separate, appropriately titled thread)

...So if you cut and paste it you'll have to do the reverse, Edit > Blank Operations > Space to Tab (Leading) for it to work as Python...

I've just realized that what I said there about tabs was a load of tosh ! :rolleyes:

---

The 3Dcheapskate* occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.

*also available in ShareCG, DAZ, and HiveWire3D flavours (the DeviantArt and CGBytes flavour have been discontinued).