EVargas posted at 7:49 PM Sat, 7 October 2023 - #4475949

Rhia474 posted at 11:39 AM Sat, 7 October 2023 - #4475930

(...) stayed at the foot of the figure. What am I doing wrong?

At the foot? Wow I'm trying to imagine what would cause that, maybe the rigging part? A good tip would to double check after each step, to make sure you are following along with the correct result before continuing. What you said never happened to me.

Well, I followed what was described. I am on Poser 13. This was a conforming clothing piece for LF1. Not sure what I am doing wrong, but I may try again tomorrow. 

1. Import the clothing's obj from the geometries folder into Poser--done.

2. Load LF2 Pro's LF1 to LF2 Prefit Tool from the props library--done.

3. Copy the LF2 shape morph from the tool to the clothing obj--done.

4. Export that obj--done.

Now you can import that obj in a new scene and take it through the fitting room or setup room --as described, done, but the import brings it to the foot of the figure and then it conforms to the foot as well.

I'm using Poser 13 in those videos, if you're on a previous version keep an eye for eventual differences (I'm not sure it there would be any...).

No, I am on Poser 13. Will attempt it again tomorrow.