Can't help you with the music, Clint, but the movement of the Poser window may have something to do with the way, Poser had been shut down last time around. I am running Poser on similare H/W to yours and also with W2k, and it always happens that the Poser window is all over the place, whenever Poser had crashed or I did shut it down by not using the propoer means (like switching off the computer w/o closing Poser before). It can also happen, if you start Poser by opening a pz3-file directly, w/o going through the import-procedure after starting-up Poser empty. However, another thing is annoying me. Since I started to run Poser on W2k, it takes incredibly long to load (appr. 3 min.) and the import window shows all the choices twice (all double entries in the dropdown window). Now, if I want to import a, say, a .obj-file (or dxf, or whatever choice you have), I must always use the last entry of that choice in the list. Otherways Poser crashes in a way that I will have to do a cold re-start of the whole caboodle. I already tried to cure this problem by re-installing Poser, but it didn't go away. Anybody have an expalnation for this???