Discard all the ProPack stuff and do it much quicker and easier, the hard way -- That isn't very hard. Find a figure that has about the same body setup as what you're working on. Open the CR2 in a text editor. (Not a word processor like Word) Use Notepad or Textpad. Edit the geometry refrences in the CR2 to point to your new OBJ. Look for something like this... figureResFile Runtime:Geometries:NerdStuff:VicChain:CorsetB.obj The line will occur twice in the CR2 be sure to change both of them. Save the file with a new name. When you open the clothing in Poser Be sure to zero ALL the channels before trying to conform it. (Check the Body too) Memorize the figure and save it back to the library. Now it's ready to be a conformer. If the figure still doesn't line up properly it's because the OBJ is in the wrong place in Poser space. You will need to re-edit the clothing in your modeler and line it up with the OBJ for the target figure. If you load the figure OBJ and the clothing OBJ they should line up perfectly in the modeling program. IF they don't you will never get it to fit right.