OK here goes Liz your problem here is you used an exported figure to model around so they won't conform properley if you can do the same but build around a figure coming straight from the gemotries folder they'll conform fine ....hers what I did...I exported the pants then lined them up with a poser figure..problem was the bottom of the pants won't line up with the figure ankles and the pants have a slight bend in the leg where as the figure doesn't...so I then exported them and edited a cr2 to point to the new pants, they conformed pretty well (apart from the ankle problems) just a little break up between hip and ab on the side, so if you redo then on a figure from geometries they should be OK :o)......Steve