Dear friends,

hope we can share experiences in adding morphs. Sometimes, if we try to add a morph to an own mesh/figure in Poser5, we sometimes get this horrible message:

Target geometry get wrong numbers of vertices.

Is there any specific way to find the reason of this warning immediately?
We often fished in troubled waters. We checked the vertices of the morph-> exact the same as the target. We copied the target, pasted into a new scenery, got our *.obj. No chance, the same error.

Sometimes (perhaps with the help of God...) after several morph-tunings in RDS it was working, the morph was accepeted by Poser.

technicals:

• own mesh, created in RDS 5
• Poser 5, own figure
• trouble in adding morph (here rButtock)

Hope you can give good advices.

Thanks a lot

Daniel + Matthias