I have built a set of wings for Poser. I would like to give them away, if anyone would like to host them. The figure uses "body handle" proxy parts and ERC for posing. The wings themselves have not been cut into parts. As far as I know, this technique has not been used before, although I may be wrong? They offer a fairly good range of motion, although there can be distortion or bad interactions with some dial combinations. They certainly flap, and I have been able to get them to fold fairly well with certain settings.... Although the feathers do "scrunch" instead of overlapping. :( The above image is not representative of the full range of motion. These are only five of the dials out of twenty-one. I cannot claim that they are fully accurate, anatomically. And the texture may be a bit loose when viewed closeup. I am not, sadly, Anton. :( This has been an experiment for me, a learning experience, and I hope they might be able to be of some use to someone. Lacking a host, I can e-mail them on request. The zip is about 650 KB.

===========================sigline======================================================

Cage can be an opinionated jerk who posts without thinking.  He apologizes for this.  He's honestly not trying to be a turkeyhead.

Cage had some freebies, compatible with Poser 11 and below.  His Python scripts were saved at archive.org, along with the rest of the Morphography site, where they were hosted.