GaryNH opened this issue on Sep 30, 2003 ยท 6 posts
GaryNH posted Tue, 30 September 2003 at 2:36 AM
Im about to do a major rebuild of my pc... So what hoops do I need to jump thru to reinstall poser 5? Do I have to do the whole re-reg thing or can I jump straight to SR ? Thanks for any advice.. Gary H
uli_k posted Tue, 30 September 2003 at 3:26 AM
Hi Gary, even if you rebuild from ground up, installing SR3 before launching Poser the first time does remove the need for registering online. Nevertheless, it is recommended for first time users to go to www.curiouslabs.com/go/register in order to be able to receive tech support.
GaryNH posted Tue, 30 September 2003 at 7:47 AM
Excellent thanks.... Poser was registered, but I have just "obtained" several new bits for the PC, so I hope to upgrade the entire thing next week. (A local company that I did some work for has died a death, and I have been given various pieces of hardware as part payment for the last job..)
joffry posted Tue, 30 September 2003 at 4:53 PM
I just re-did my 'puter today, new motherboard, processor and then 1.5gigs ram. When I came home and tried to load poser, it looked like it was going to load then didn't. Wasn't looking forward to a re-install so just went up and downloaded SR3 again and installed, now works like a charm, and a wee bit faster than before.
GARYNH1 posted Wed, 01 October 2003 at 4:09 PM
I will have a 3Ghz Pent 2.5Gb RAM 240 Gb HD 1 X 19" Monitor and 1 X 17" flatpanel screen 1 128Mb ATI 9200 graphics card So I hope poser will be reasonably quick...
joffry posted Wed, 01 October 2003 at 4:26 PM
I only got a chance to play this morning and put it thru it's paces, renders a lot faster, M3 doesn't bog it down anymore, no problems with ram anymore. Very pleased. Very broke, but very pleased.