Forum: Poser - OFFICIAL


Subject: Restricting some Movement??

grid opened this issue on Feb 03, 2004 ยท 2 posts


grid posted Tue, 03 February 2004 at 5:27 PM

I was woundering if There is a good way to Go about Restricting Movement to a joint of comforming Clothing? I would like one part of the joint to be able to go up But When it comes down on the same y/z axes I would like it to stop at a exact spot. Alowing the arm of the figure to keep going. Whould this have to bye a cr2 fix?


xantor posted Wed, 04 February 2004 at 12:57 AM

You might be able to do that editing the joints of the cloth but I am not sure without the details...